How to install VDSL on a Raw Copper line

• en
• »
• Support
• »
• Installation & usage
• »
• Internet
• »
• How to install VDSL on a Raw Copper line

I want to install the modem close to the NTP

1. Make sure NTP 2007 is installed at the entry point in your house/apartment.

2. Connect your modem/router to the NTP with a DSL/internet cable. 

• Insert the cable into the DSL/WAN port on the modem/router.
• Insert the free end of the cable into the free port on the NTP.

3. Connect the power supply unit of your modem/router to the port on your modem/router labeled “POWER” or “PWR”.

4. Plug the other end of the power supply into an AC power outlet.

5. Check if the DSL LED starts flashing.

I want to install the modem on another phone socket

1. Make sure NTP 2007 is installed at the entry point in your house/apartment.

2. Connect your other phone socket to the blue connector inside the NTP by means of a separate cable used only for a modem/router connection. This is an ordinary phone cable (a VVT-cable or a less preferable UTP-cable) that can be bought at any electrical shop.

3. Install a VDSL2-splitter on all your phone sockets including the NTP. 

NOTE! Make sure the switches on your VDSL splitter are in the ON-position.

4. Connect your modem/router to the phone socket with a DSL/internet cable. 

• Insert the cable into the DSL/WAN port on the modem/router.
• Insert the free end of the cable into the free port on the phone socket or a splitter.

5. Connect the power supply unit of your modem/router to the port on your modem/router labeled “POWER” or “PWR”.

​

6. Plug the other end of the power supply into an AC power outlet.

7. Check if the DSL LED starts flashing.